Use current maps as the model input
Represent the load produced by displayed video as a pixel-current map. This connects temperature estimation to the content being driven on the panel.
From a physical model to a hardware datapath
I developed a pixel-level thermal model that turns video-derived current maps into temperature estimates through 2D heat diffusion. The work adapted the algorithm to real-time display hardware and reached RTL handoff before tape-out.
Explore the approach ↓Panel temperature depends on both the video-dependent electrical load and heat transfer between neighboring pixels. A pixel-wise estimator must capture this spatial behavior while fitting the execution constraints of a real-time display pipeline. The central engineering task was to make a physical thermal model usable as a hardware algorithm.
Represent the load produced by displayed video as a pixel-current map. This connects temperature estimation to the content being driven on the panel.
Develop a pixel-wise prediction algorithm based on two-dimensional heat diffusion. Neighboring locations contribute to the estimated thermal state, capturing the spatial behavior that a purely independent per-pixel estimate would miss.
Optimize the algorithm against implementation constraints and carry the model through RTL handoff before tape-out. The work joins physical modeling with the requirements of the display datapath.
Developed the thermal-prediction algorithm and adapted it to hardware implementation constraints.
I developed the thermal-prediction algorithm, adapted it to real-time hardware constraints, and completed RTL handoff prior to tape-out. The project demonstrates the conversion of a spatial physical model into an implementable estimation pipeline.